IS215ACLEH1BC GE EX2100, 400 MHz Processor Card

Description:

The IS215ACL Application Control Layer Module (ACL) is a microprocessorbased master controller used to perform multiple duties over communicationnetworks such as Ethernet'M and ISBus, The ACL mounts in a standard InnovationSeriesrm drive or EX2100 exciter board rack and occupies two half-slots. The ACLand board rack are located in the control cabinet. In drive applications, the ACL's Piconnector (4-row 128-pin) plugs into the Control Assembly Backplane Board(CABP).In the EX2100 exciter, the ACL mounts in the Exciter Backplane (EBKP)

The ACL can be ordered in two different I/O configurations as follows.

IS215ACLAH1A Module with one 10BaseT Ethernet port and two serialcommunication ports (COM1 and COl2), as used in the EX2100IS215ACLIH1A Module with one 10BaseT Ethernet port, two serialcommunication ports (COMl and COM2), and two ISBus ports

Refer to Figure 1 for the module faceplates.Optional hardware accessories are available. These items must be ordered separatelyfrom the ACL and include the following.

• Serial adapter cable (336A4929G1)
• Serial cable(336A3582P1)

• Control blockware language and library
• Online application configuration loading
• I/O points and internal Booleans forcing
• Diagnostics for broken run/start permissives
• Application level alarm messages
• Non-volatile flash memory
• Toolbox interface and support through Ethernet
• Application control for Innovation Series drives

Frequently Asked Questions:

1.What is the interface of IS215ACLEH1BC?
Enternet

2.Whats's the Bios of IS215ACLEH1BC?
BlOS is a 1 MB (128 KB x 8) 5 V flash memory device and mounts in a socket onthe ACL. See Table 4, Basic BIOS Settings, for settings accessible through thetoolbox, as well as through the setup utility. The BIOS will redirect the video displayto COll if a video BIOS is not found (if there is no PC/104 VGA board installed).

Datasheet Link:

IS215ACLEH1BC GE EX2100, 400 MHz Processor Card PDF Datasheet