IS200JPDCG1A GE MarkVIe, Power Distribution Card

Description:

IS200JPDCG1A GE MarkVIe, Power Distribution Card in stock.

Welcome to inquiry.

The IS200JPDC Power Distribution Module (JPDC) combines input and output functions from several previous designs to provide distribution of 125 V dc, 115/230 V ac, and 28 V dc to other boards within a turbine control system.

Compatibility

JPDC can host a Power Distribution System Feedback (PPDA) pack used in the Mark* VIe Power Distribution System. JPDC can also receive diagnostic feedback signals from other distribution boards and route these signals to the PPDA I/O pack as well.
The intent is that the PPDA I/O pack should be mounted on the JPDC module. Therefore, no provision is made to transmit diagnostic signals from JPDC to another distribution board.

Installation

The JPDC module is typically mounted vertically with the 115/230 V ac input connector (JAC) at the bottom. It is attached with four screws using the mounting holes located at the top and bottom of the module base. Location within the control cabinet is not critical, however, distribution boards are usually mounted low in the cabinet to facilitate grounding. Refer to the section, Grounding.

The optional PPDA I/O pack is plugged into connector JA1. It is secured to the JPDC base using an angle bracket, held in place with nuts threaded onto studs, that are permanently attached to the base for that purpose.

Datasheet Link:

IS200JPDCG1A GE MarkVIe, Power Distribution Card PDF Datasheet